Draper Expert Cooling System Pressure Test Kit (15 Piece) - 21439

Draper Expert Cooling System Pressure Test Kit (15 Piece)

ref: 21439 / URPTK-2

• This universal pressure test kit is designed to test and measure the pressure in vehicle cooling systems via the radiator or expansion tank and is intended for trade use.
• A capless tester, it uses a cone adaptor system to seal and pressurise the cooling system.
• Cone adaptors may be used to replace both screw and bayonet-type cap fittings.
• The kit includes a hand pump with a gauge to enable simple, easily controlled testing, with a release pin for depressurisation prior to detachment.
• There are also four universal cone adaptors and ten radiator cap testing adaptors for use on a wide range of vehicles.
• The kit is supplied in a sturdy, blow-moulded plastic case.

• 1 x Pump with gauge
• 4 x Cone adaptors: 17-24, 28-31.5, 37-39.5, 47-48.5mm
• 1 x Radiator cap adaptor 21: Ford (after 2010) pressure caps
• 1 x Radiator cap adaptor 22: Toyota and Honda pressure caps
• 1 x Radiator cap adaptor 23: Mitsubishi, Ford, Nissan and Mazda pressure caps
• 1 x Radiator cap adaptor 24: Nippon and Hino pressure caps
• 1 x Radiator cap adaptor 25: Renault and Audi/VW pressure caps
• 1 x Radiator cap adaptor 26: Volvo, Citroen, Renault, Fiat and Peugeot pressure caps
• 1 x Radiatorcap adaptor 27: Opel, VW and Ford pressure caps
• 1 x Radiator cap adaptor 28: Volvo and Renault pressure caps
• 1 x Radiator cap adaptor 29: BMW pressure caps
• 1 x Radiator cap adaptor 30: Mercedes-Benz pressure caps
• Supplied in a blow-moulded plastic case